circular-saw-blades

Tip circular saw blades

Tip circular saw blades

Saw diameters and bore sizes.
Find the right saw blade fitting to your Tip circular saw machine.

Whatever machinery you have, mount a compatible blade measuring the full size. Substituting a close enough undersized diameter may be possible, but not ideal.


Tip

modelnumber size
HKS160
160 x 20 mm
HKS200
200 x 16 mm
TKS250
250 x 15,8 mm
TGS250
250 x 25,4 mm


Always work with sharp tools for the best result and safety. Wear safety glasses, work gloves and ear protection if possible, when you work with machines.
circular-saw-blade

Nothing can be found of the Tip brand that once marketed sawing machines.
Probably it was once marketed by a German manufacturer, given the type designations HKS and TKS that the Germans usually use for hand-held circular saw and table saw.
We have however been able to find out the dimensions of the saw blades for some machines. So for the individual who still has a sowing table, we have listed these sheets.



Tip woodworking machines

carpentry-workshop
Old carpentry workshop

choose region for int.traders



extra


Circular saw blades have different sizes from a few inches to several feet across. Diameter is the span from one edge of the circle to the other measured along a center line. The radius is half that; it is the span from the center to the edge. A saw doesn't have the capacity to cut that deep, though. Maximum depth of cut is less than the radius. It cuts no deeper than 1/3 of its diameter. A 10" saw cuts about 3" deep at maximum capacity, and usually less. A big blade has greater cutting depth. Not only can a larger blade cut deeper, it also has a larger circumference, or the measurement around the rim. A longer cutting length around the circumference makes space for more tips overall. For this reason, bigger blades have longer endurance. Small blades have less circumference circling the rim, which explains how fast they get used up. A big one might last the equivalent of two smaller ones. However, large sizes won't necessarily allow faster feed; coarseness determines that.

Copyright © 2019 -
SuRish int. - all rights reserved